Front Differential Carrier Bearing Cup and Washer Replacement - Torque Converter Housing Side
|
|
Front Differential Carrier Bearing Cup and Washer Replacement - Torque Converter Housing Side
|
|
Callout
|
Component Name
|
Preliminary Procedures
|
•
|
Do not install the bearing cup until after the selective washer measurement has been performed.
|
|
|
1
|
Front Differential Bearing Thrust Washer
|
|
2
|
Front Differential Carrier Bearing Cup
Warning
|
|
Support the back side of the torque converter housing before installing the bearing cup. Apply a light coating of transmission fluid to the bore before pressing the cup into position. Install the bearing cup until it stops moving. Applying excessive pressure to the bearing cup once it is seated could cause damage to the torque converter housing casting.
|
|
|
|
|
|
|
Warning
|
|
An unseated or improperly installed bearing cup will result in premature bearing failure. Visually inspect the bearing cup to insure there is no "clearance" between the converter housing, thrust washer, and the bearing cup. Use of a feeler gauge may assist in identifying a bearing cup that is not fully seated.
|
|
|
|
|
|
|
Warning
|
|
Failure to apply the lubricant will cause damage to the bolt and nut threads.
|
|
|
|
|
|
Procedure
|
1.
|
Tighten DT 47927-1 which is part of
DT-47927
bearing cup remover until it fits snugly on the bearing cup.
|
|
2.
|
Adjust
DT 45124
removal bridge so it sits on the torque converter housing surface just beyond the bearing cup opening.
|
|
3.
|
Apply the extreme pressure lubricant supplied with
DT 23444-A
extreme press lubricant to the puller bolt threads to prevent damage to the bolt threads during bearing cup removal.
|
|
4.
|
Hold the puller bridge bolt and turn the nut to remove the bearing cup.
|
Special Tools
|
•
|
DT 23444-A
Extreme Press Lubricant - 1/4 Ounce Tube
|
|
•
|
DT-45087
Bearing Cup Installer
|
|
•
|
DT 45124
Removal Bridge
|
|
•
|
DT-47927
Bearing Cup Remover
|
For equivalent regional tools, refer to
Special Tools
.
|
