SAAB WIS ONLINE

PRE-RELEASE

Parking Brake Rear Cable Replacement - Left Side (All Wheel Drive)

Parking Brake Rear Cable Replacement - Left Side (All Wheel Drive)


Special Tools

CH-37043 Parking Brake Cable Release Tool

For equivalent regional tools, refer to Special Tools .

Removal Procedure

Refer to Brake Dust Warning .


1. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling .

2. Turn the ignition to the OFF position.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

5. Remove the parking brake shoes. Refer to Parking Brake Shoe Replacement .

6. Lower the rear suspension support approximately 152-254 mm (6-10 in). Refer to Rear Suspension Support Replacement (AWD) Rear Suspension Support Replacement (FWD) .

7. Disconnect the left parking brake cable fitting (1) from the parking brake intermediate cable connector.


8. Using the CH-37043 Parking Brake Cable Release Tool , compress the locking tabs on the left parking brake cable conduit (1) and remove the cable from the rear frame bracket.


9. Remove the left parking brake actuator assembly spring clip (1).


10. Press the parking brake actuator arm inward and release the parking brake rear cable fitting from the actuator.

11.
Note

The parking brake rear cable is secured to the rear suspension knuckle with an integral spring clip interference fit.


Grasp the parking brake rear cable (1) and pull the cable assembly inward to release the cable conduit from the rear suspension knuckle.


12. Remove the parking brake rear cable.


Installation Procedure


1.
Note

The parking brake rear cable is secured to the rear suspension knuckle with an integral spring clip interference fit.


Insert the parking brake rear cable (1) into the rear suspension knuckle.


2. Ensure the parking brake rear cable is inserted fully into the rear suspension knuckle.

3. Press the parking brake actuator arm inward and install the parking brake rear cable to from the actuator.


4. Install the left parking brake actuator assembly spring clip (1).

5. Install the parking brake rear cable and conduit (1) to the rear frame bracket.


6. Ensure the parking brake rear cable conduit locking tabs are fully engaged to the rear frame bracket.

7. Connect the left parking brake cable fitting (1) to the parking brake intermediate cable connector.


8. Install the rear suspension support. Refer to Rear Suspension Support Replacement (AWD) Rear Suspension Support Replacement (FWD) .

9. Install the parking brake shoes. Refer to Parking Brake Shoe Replacement .

10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .

11. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling .


PRE-RELEASE