PRE-RELEASE
DTC B0052
| DTC B0052 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using the diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptors |
DTC B0052 00
Deployment Commanded Malfunction
DTC B0052 56
Deployment Commanded Too Many Transitions
| Circuit/System Description |
The inflatable restraint sensing and diagnostic module (SDM) senses vehicle impacts and provides deployment signals to the air bags and anchor and/or retractor pretensioners when warranted. The SDM sets DTC B0052 after each deployment command. DTC B0052 will latch and not clear after 3 commanded deployments by the SDM. And therefore the SDM has to be replaced using end of life disposal procedure.
| Conditions for Running the DTC |
Ignition voltage is between 9-16 V.
| Conditions for Setting the DTC |
| • |
The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal air bags.
|
|
| • |
The SDM detects a side impact or rollover (if equipped) of sufficient force to warrant deployment of a seat side air bag and/or roof rail air bag.
|
|
| Action Taken When the DTC Sets |
The SDM requests the instrument cluster to illuminate the AIR BAG indicator.
| Conditions for Clearing the DTC |
| • |
DTC B0052 00 is a clearable DTC and may be cleared with a scan tool without replacing the SDM.
|
|
| • |
DTC B0052 56 is a latched DTC. The DTC cannot be cleared with the scan tool. Replacement of the SDM is required.
|
|
| Reference Information |
Schematic Reference
SIR Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| 1. |
Verify that DTC B0052 00 is not set.
|
|
| 2. |
If DTC B0052 00 is set
Clear the DTC. |
|
| 3. |
If DTC B0052 00 is not set
|
|
| 4. |
Verify that DTC B0052 56 is not set.
|
|
| 5. |
If DTC B0052 56 is set
Replace K36 Inflatable restraint sensing and diagnostic module (SDM). |
|
| 6. |
If DTC B0052 56 is not set
|
|
| 7. |
All OK.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the repair.
Control Module References for SDM control module replacement, programming and setup
