PRE-RELEASE
Front Seat Cushion Cover and Pad Replacement
| Front Seat Cushion Cover and Pad Replacement |
| Removal Procedure |
| 1. |
Remove the front seat. Refer to
Driver or Passenger Seat Replacement
.
|
|
| 2. |
Remove the front seat adjuster, if equipped. Refer to
Front Seat Adjuster Replacement
.
|
|
| 3. |
Remove the front seat outer adjuster finish cover. Refer to
Driver or Passenger Seat Outer Adjuster Finish Cover Replacement
.
|
|
| 4. |
Remove the front seat inner recliner finish cover. Refer to
Driver or Passenger Seat Inner Recliner Finish Cover Replacement
.
|
|
| 5. |
Remove the rear retainers on the seat cushion cover from the seat frame.
|
|
| 6. |
Disengage the J-channel retainers from the seat frame.
|
|
| 7. |
Disconnect the electrical connector, if equipped.
|
|
| 8. |
Disconnect the duct from the vent fan, if equipped.
|
|
| 9. |
Remove the seat cushion cover and pad (1) from the seat cushion frame as an assembly.
|
|
| 10. |
Remove the hog rings from the under side of the seat cover.
|
|
| 11. |
Pull the cushion cover (1) off of the pad (2).
|
|
| 12. |
When replacing the front passenger seat cushion, you must also replace the inflatable restraint passenger presence system. Refer to
Inflatable Restraint Front Passenger Presence Sensor Replacement
.
|
|
| Installation Procedure |
| 1. |
Pull the vertical listing wires (1) rearward partially out of the trim cover (2) before placing the trim cover on the pad.
|
|
| 2. |
Install hogrings in position 1 through 3, attaching the cover to the pad (1).
|
|
| 3. |
Pull the listing wires forward into the design position.
|
|
| 4. |
Install hogrings in position 4 through 9, attaching the cover to the pad (1).
|
|
| 5. |
Install the seat cushion cover and pad (1) to the seat cushion frame as an assembly.
|
|
| 6. |
Connect the duct from the vent fan, if equipped.
|
|
| 7. |
Connect the electrical connector, if equipped.
|
|
| 8. |
Install the J-channel retainers to the seat frame.
|
|
| 9. |
Install the rear retainers on the seat cushion cover to the seat frame.
|
|
| 10. |
Install the front seat inner recliner finish cover. Refer to
Driver or Passenger Seat Inner Recliner Finish Cover Replacement
.
|
|
| 11. |
Install the front seat outer adjuster finish cover. Refer to
Driver or Passenger Seat Outer Adjuster Finish Cover Replacement
.
|
|
| 12. |
Install the front seat adjuster, if equipped. Refer to
Front Seat Adjuster Replacement
.
|
|
| 13. |
Install the front seat. Refer to
Driver or Passenger Seat Replacement
.
|
|
| 14. |
When working with the passenger seat, you must test for a preload to the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to
Control Module References
.
|
|
