PRE-RELEASE
Brake servo, RHD
| Brake servo, RHD |
| 1. |
Remove the master cylinder, see
.
|
|
| 2. |
Remove the wiper arms and cover panel over the wiper mechanism.
|
|
| 3. |
Disconnect the vacuum hose from the brake servo.
|
|
| 4. |
Remove the crankcase breather valve and its hoses to provide more working space.
|
|
| 5. |
Undo the brake servo bracket's retaining bolt and two retaining nuts from the front bulkhead partition.
|
|
| 6. |
Remove the cover panel under the dashboard.
|
|
| 7. |
Unhook the brake pedal return spring.
|
|
| 8. |
Remove the clip and the pedal's through pin.
|
|
| 9. |
Lift out the brake servo.
|
|
| 10. |
If fitting a replacement unit, transfer the bracket to the new brake servo.
|
|
| To fit |
| 1. |
Correctly position the brake servo bracket and tighten the retaining bolt and two retaining nuts.
|
|
| 2. |
Fit the crankcase breather valve and hoses.
|
|
| 3. |
Connect the vacuum hose to the brake servo.
|
|
| 4. |
Fit the cover panel and wiper arms.
|
|
| 5. |
Fit the master cylinder, see
.
|
|
| 6. |
Fit the through pin and circlip and hook the return spring in place.
|
|
