PRE-RELEASE
Rear seat backrest upholstery, 4D
| Rear seat backrest upholstery, 4D |
| 1. |
Remove the backrest from the car, see
.
|
|
| 2. |
Remove the hinge plates, 2 x for the 40% backrest and 1 x for the 60% backrest.
|
|
| 3. |
Release the upholstery strips along the edge and around the catches.
On the 60% backrest, release the upholstery strips around the load hatch. |
|
| 4. |
Detach the foam cushion reinforcing plate from the back plate and lift it out.
|
|
| 5. |
Cut the staples securing the seat upholstery to the foam cushion.
|
|
| 6. |
Remove the seat upholstery.
|
|
| To fit |
| 1. |
Fit the upholstery to the backrest foam cushion.
|
|
| 2. |
Fit the staples using the pliers in fitting kit 84 71 062.
|
|
| 3. |
Roll the upholstery over the edges of the foam cushion and turn it over.
|
|
| 4. |
Lay the back plate in place and fit the catches.
|
|
| 5. |
Fit the foam cushion reinforcing plate to the back plate and replace the upholstery strips along the edge.
On the 60% backrest, replace the upholstery strips around the load hatch. |
|
| 6. |
Replace the hinge plates.
|
|
| 7. |
Replace the backrest in the car, see
.
|
|
