SAAB WIS ONLINE

PRE-RELEASE

Yaw rate sensor

Yaw rate sensor

To remove


1. Remove the centre console, see To remove .


2. Manual gearbox: Remove the gear lever housing, see To remove .

Automatic transmission: Remove the selector lever housing, see To remove .

3. Remove the gyro sensor. Use a large screwdriver to prise aside the air duct slightly to access the left-hand screw.

4. Unplug the connector from the gyro sensor.

Note

The connector has a locking device that must be released.



To fit


1. Plug in the gyro sensor.

2. Fit the gyro sensor to the bracket. Use a large screwdriver to prise aside the air duct slightly to access the left-hand screw.

Important

Fit the gyro sensor with the connector and arrow pointing forward in the car.



Tightening torque up to and including Vehicle Identification Number 73514907:

10 Nm (7 lbf ft)

Tightening torque from and including Vehicle Identification Number 73514908:

8 Nm (6 lbf ft)

3. Manual gearbox: Fit the gear lever housing, see To fit .

Automatic transmission: Fit the selector lever housing, see To fit .

4. Fit the centre console, see To fit .


PRE-RELEASE