PRE-RELEASE
Rear bumper shell/cellular block, 5D
| Rear bumper shell/cellular block, 5D |
| Removing |
| 1. |
Remove
Rear bumper, 5D
. Place it on a well protected work bench.
|
|
| 2. |
Remove
Upper rear protective shell, 5D
.
|
|
| 3. |
Remove the cellular blocks.
|
|
| 4. |
Cars with SPA
: Remove the connector from the holder.
|
|
| 5. |
Detach the bumper rail from the protective shell by releasing the retaining clips.
|
|
| 6. |
Remove the cellular blocks from the protective shell (wedged into the protective shell's retaining wedges).
|
|
| 7. |
Cars with SPA
: Remove the connectors.
|
|
| 8. |
When replacing the bumper shell, transfer the lower spoiler.
Cars with SPA : Transfer the sensor and holder. |
|
| Fitting |
| 1. |
Cars with SPA
: When replacing the cellular block, transfer the wiring harness. Plug in the connectors.
|
|
| 2. |
Fit the cellular blocks in the bumper shell.
|
|
| 3. |
Cars with SPA
: Marke sure the connector holder is correctly positioned on the bumper rail.
|
|
| 4. |
Guide the bumper rail into the bumper shell guide pin. Fit the bumper rail to the bumper shell.
|
|
| 5. |
Cars with SPA
: Fit the connector on the holder.
|
|
| 6. |
Fit the cellular blocks.
|
|
| 7. |
Fit
Upper rear protective shell, 5D
.
|
|
| 8. |
Fit
Rear bumper, 5D
.
|
|
