PRE-RELEASE

Oil pump seal ring, replacement

To remove

1.	Remove the timing belt. See Timing belt (in situ) .

2.	Remove the timing belt gear using 32 025 006 Crankshaft holder together with 83 95 360 Holding tool, crankshaft pulley . Note The bolt is left-threaded.

3.	Remove the oil pump seal ring by prising it out of the oil pump with a suitable tool. Make sure that the sealing surfaces are not damaged.

4.	Clean the sealing surfaces.

To fit

1.	Moisten the gasket's seal lip with a little silicone paste (white) and fit the oil pump seal ring. Use 32 025 014 Fitting tool, oil pump seal .

2.	Fasten the timing belt gear to 32 025 006 Crankshaft holder .

3.	Fit the timing belt gear using 32 025 006 Crankshaft holder together with 83 95 360 Holding tool, crankshaft pulley . Tightening torque: 340 Nm (251 lbf ft)

4.	Remove the special tools.

5.	Fit the timing belt. See Timing belt (in situ) .

6.	Check the engine oil level. Top up as necessary. See Recommended oil grade .

PRE-RELEASE

This project is supported by memberships and donations. If you use this site, please consider Joining SCNA and/or making a donation.

Our Friends