SAAB WIS ONLINE

PRE-RELEASE

Headlamp Leveling Actuator Replacement (Halogen)

Headlamp Leveling Actuator Replacement (Halogen)

Removal Procedure


1. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .

2. Remove the headlamp. Refer to Headlamp Replacement .

3. Remove the headlamp bulb low beam. Refer to Headlamp Bulb Replacement (Xenon - Left Side) Headlamp Bulb Replacement (Xenon - Right Side) Headlamp Bulb Replacement (High Beam) Headlamp Bulb Replacement (Low Beam) .

4. Remove the headlamp bulb dust covers.

5. Rotate the adjuster (horizontal/vertical) with a 6 mm Allen key clockwise to the block.


6. Rotate the headlight leveling actuator with a screwdriver clockwise at 60° (headlamp left side; headlamp right side counter clockwise).


7. Move the headlight leveling actuator in upper direction, until the headlight range adjuster is detached from the reflector.

8. Remove the headlamp leveling actuator through the low beam opening and disconnect the electrical connector.



Installation Procedure


1. Connect the electrical connector on the new headlamp leveling actuator.

2. The new headlamp leveling actuator must be mounted centered through the guide slide.


3. Engage the new headlamp leveling actuator with the guide slide of the reflector.

Open the high beam dust cover and push the guide slide with an applicable tool in direction of the new headlamp leveling actuator.


4. Push now the headlamp leveling actuator ball head into the guide slide and rotate the actuator counter clockwise about 60° (headlamp left side; headlamp right side clockwise).

5. Rotate the adjusting screw (horizontal/vertical) clockwise into base position (5 revolutions).

6. Install the headlamp bulb low beam. Refer to Headlamp Bulb Replacement (Xenon - Left Side) Headlamp Bulb Replacement (Xenon - Right Side) Headlamp Bulb Replacement (High Beam) Headlamp Bulb Replacement (Low Beam) .

7. Install the dust covers for low and high beam.

8. Install the headlamp. Refer to Headlamp Replacement .

9. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement .

10. Adjust the headlamp. Refer to Headlamp Aiming (Base) Headlamp Aiming (Check and Adjust) .


PRE-RELEASE