Torque Converter Replacement
|
|
Torque Converter Replacement
|
|
Callout
|
Component Name
|
Preliminary Procedure
|
3.
|
Place a drain pan under the vehicle.
|
|
1
|
Torque Converter
Warning
|
|
Support the back side of the torque converter housing while installing the seal. Install the seal until it stops moving. Applying excessive pressure to the seal once it is seated could cause damage to the torque converter housing casting.
|
|
|
|
|
|
Procedure
|
1.
|
Mount the
DT-899
Torque converter Remover/Installer to the converter and lift it out.
|
|
2.
|
Check that the torque converter has reached the correct position by placing a steel ruler on the torque converter shell"s mating surface and measure the surface between the mating surface and the driving plate contact surface on the torque converter. The distance should be:
|
|
|
•
|
LAU/A28NER: at least 9 mm.
|
|
|
•
|
LDK/A20NHT: at least 9 mm.
|
|
|
•
|
LBS/A20DTH: min. 15 mm.
|
Special Tools
DT-899
Tourque converter Remover/Installer
For equivalent regional tools, refer to
Special Tools
.
|
