PRE-RELEASE
Aerial rod (power aerial)
| Aerial rod (power aerial) |
| 1. |
Remove the power aerial, see
.
|
|
| 2. |
Remove the screws securing the aerial tube and withdraw the tube.
|
|
| 3. |
Connect the motor to a 12 V battery and wait until it stops with the aerial
extended. Then carefully pull the antenna tube gear rack out of the motor.
|
|
| 4. |
Introduce the new gear rack into the motor with the teeth facing the motor. Apply
a little grease to the gear rack.
|
|
| 5. |
Connect the motor to the battery again while carefully inserting the gear rack.
|
|||||||
| 6. |
When the entire gear rack has been wound in, disconnect the battery.
|
|
| 7. |
Fit the aerial tube.
Make sure that the tube is the right way round. 
|
|
| 8. |
Fit the aerial, see
.
|
|
