PRE-RELEASE
INSTALLATION
| INSTALLATION |
Connect the inhibitor switch harness connector to inhibitor switch.
Install the inhibitor switch to transmission case.
|
(A)
|
Inhibitor
switch
|
Move the range select lever to neutral position.
Using the ST, tighten the bolts of inhibitor switch.
STÂ 32005129 STOPPER PIN
Tightening torque:3.5 Nm (0.36 kgf-m, 2.6 ft-lb)
|
(A)
|
Inhibitor
switch
|
|
(B)
|
Range select
lever
|
Install the select cable to range select lever.
Install the plate assembly to transmission.
Tightening torque:
T: 25 Nm (2.5 kgf-m, 18.1 ft-lb)
|
(A)
|
Select
cable
|
|
(B)
|
Plate ASSY
|
Install the washer and snap pin to range select lever.
|
(A)
|
Range select
lever
|
|
(B)
|
Snap ring
|
|
(C)
|
Select
cable
|
|
(D)
|
Washer
|
Install the front and center exhaust pipes. (Saab 9-2X 2.5i Linear)
Install the center exhaust pipe. (Saab 9-2X 2.0T Aero)
Lower the vehicle.
Install the inhibitor switch connector from stay.
Connect the inhibitor switch connector.
|
(A)
|
Inhibitor
switch
|
Install the air intake chamber. (Saab 9-2X 2.5i Linear)
Install the intercooler. (Saab 9-2X 2.0T Aero)
Inspect the inhibitor switch.
