Bush, front anti-roll bar, replacement, 4WD
|
|
Bush, front anti-roll bar, replacement, 4WD
|
|
3.
|
Remove the bolt and nut which attach the suspension arm to the steering swivel member on both sides (A).
|
|
4.
|
Lower the subframe.
|
Important
|
|
Replace one side at a time.
|
|
|
|
Important
|
|
Do not lubricate the bushing or anti-roll bar when removing/installing.
|
|
|
|
|
5.
|
Position the anti-roll bar on the subframe and fit its right mounting (A).
|
|
6.
|
Remove the cap from the left-hand bush (B).
|
|
7.
|
Remove the left-hand bush.
|
Note
|
|
The removed bush must not be reinstalled. It must be replaced.
|
|
|
1.
|
Position the bush (A) on the subframe, centred between the bolt holes.
|
Important
|
|
Soap and water solution must not enter between bushing and anti-roll bar!
|
|
|
|
|
2.
|
Apply a thin coat of soapy water on the outside of the bush.
Fit the cap to the subframe. Tighten the bolts (A) alternately until the bush hooks (B) into the cap.
|
|
3.
|
Replace the temporary bolts (M8x30 mm) with original bolts and tighten.
Tightening torque 18 Nm (13 lbf ft).
|
|
4.
|
Replace the right anti-roll bar bush following the same method.
|
|
5.
|
Remove the anti-roll bar from subframe.
|
|
7.
|
Fit the bolt and nut (B) which attach the suspension arm to the steering swivel member on both sides.
Warning
|
|
Press up the pin carefully.
|
|
The groove in the pin must be visible in the screw hole in the spindle housing.
|
|
If the rubber gaiter is pressed down, it will not seal properly to the swivel pin.
|
|
|
|
|
|
|
|
9.
|
Check the straight-ahead position of the steering wheel when driving on a level road. Adjust if necessary
|
