PRE-RELEASE
DTC B0000
| DTC B0000 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC B0000 5A
Vehicle Speed Information Circuit Not Plausible
| Diagnostic Fault Information |
| Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
| Signal Terminal 20 X4 | B0000 5A | B0000 5A | B0000 5A | B0000 5A |
| Circuit/System Description |
The radio receives a vehicle speed signal from the electronic brake control module (EBCM) in order to correlate actual vehicle speed to the movement of the vehicle calculated by the navigation system and reported serial data.
| Conditions for Running the DTC |
| • |
Radio ON.
|
|
| • |
Battery voltage must be between 9-16 V.
|
|
| Conditions for Setting the DTC |
| • |
Vehicle speed from serial data is more than 5 km/h (3 mph) and vehicle speed pulse from the EBCM is 0 km/h (0 mph).
|
|
| • |
Vehicle speed calculated from the navigation processing software is more than 36 km/h (22 mph) and vehicle speed pulse from the EBCM is 0 km/h (0 mph) for 10 seconds continuously.
|
|
| Action Taken When the DTC Sets |
| • |
Turn by turn route navigation may be inoperative.
|
|
| • |
Vehicle indicated location may be inaccurate.
|
|
| Conditions for Clearing the DTC |
| • |
The condition responsible for setting the DTC no longer exists.
|
|
| • |
A history DTC will be cleared after 100 malfunction-free ignition cycles.
|
|
| Reference Information |
Schematic Reference
Radio/Navigation System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Radio/Audio System Description and Operation
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Testing |
| Note | ||
|
Diagnose any antilock brake system (ABS) related DTCs before performing this diagnostic. |
| 1. |
Ignition OFF, disconnect the X4 harness connector at the A11 Radio.
|
|
| 2. |
Ignition ON, operate the vehicle drive wheels at 5 mph. Test for 3-7 Hertz between the signal circuit terminal 20 and ground.
|
|
| 3. |
If not within the specified range, test the signal circuit terminal 20 for an open, high resistance, short to ground or short to voltage. If the circuit tests normal replace the K17 EBCM.
|
|
| 4. |
If the circuit tests normal, replace the A11 radio.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for radio or EBCM replacement, setup, and programming
