PRE-RELEASE
DTC P1761
| DTC P1761 |
| Diagnostic Instructions |
| • |
Perform the
Diagnostic System Check - Vehicle
prior to using this diagnostic procedure.
|
|
| • |
Review
Strategy Based Diagnosis
for an overview of the diagnostic approach.
|
|
| • |
Diagnostic Procedure Instructions
provides an overview of each diagnostic category.
|
|
| DTC Descriptor |
DTC P1761
Up and Down Shift Switch Signal Message Counter
| Circuit/System Description |
A signal circuit is provided by the body control module (BCM) to the resistor network embedded in the plus or minus buttons. When a plus or minus button is pressed, a corresponding voltage drop occurs across the resistor network. This voltage drop is monitored by the BCM. The BCM will send the request to the transmission control module (TCM) to perform the upshift or downshift. The TCM is constantly monitoring the serial data sent from the BCM for the correct number and sequence of counts for Tap Up and Tap Down function.
| Conditions for Running the DTC |
| • |
The TCM rolling counter diagnostic is enabled.
|
|
| • |
The Tap Up and Tap Down message health is received from the BCM.
|
|
| • |
The engine speed is 400 RPM or greater for 5 seconds.
|
|
| Conditions for Setting the DTC |
The TCM detects an error in the rolling count value that does not match with the BCM count, 3 times within 10 seconds.
| Action Taken When the DTC Sets |
| • |
DTC P1761 is a Type C DTC.
|
|
| • |
The TCM inhibits Tap Up/Down function.
|
|
| • |
The TCM inhibits manual shifting of forward gears.
|
|
| Conditions for Clearing the DTC |
DTC P1761 is a Type C DTC.
| Reference Information |
Schematic Reference
| • |
Automatic Transmission Controls Schematics
|
|
| • |
Data Communication Schematics
|
|
| • |
Body Control System Schematics
|
|
Connector End View Reference
| • |
Component Connector End Views
|
|
| • |
Inline Harness Connector End Views
|
|
Description and Operation
Electronic Component Description
Electrical Information Reference
| • |
Circuit Testing
|
|
| • |
Connector Repairs
|
|
| • |
Testing for Intermittent Conditions and Poor Connections
|
|
| • |
Wiring Repairs
|
|
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
| Circuit/System Verification |
| 1. |
DTC P1761 is an information dtc. Troubleshoot all other panel module fault codes before DTC P1761. See
Fault code (DTC) List - Car
.
|
|
| 2. |
If there are no other panel control module DTCs, diagnosis is performed by looking for a repeating CAN-circuit fault. Go to
The scan tool does not communicate with the high-speed GMLAN unit
.
|
|
| 3. |
After you complete the steps described above, check that the diagnostic trouble code does not return by driving the vehicle according to the conditions for running diagnostic trouble codes (DTC). You can also drive the vehicle according to the conditions you have seen in Freeze Frame/Failure records. If the vehicle passes the Circuit/System Verification procedure, refer to
Testing for Intermittent Conditions and Poor Connections
.
|
|
| Repair Instructions |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Perform the Resetting of the transmission's adaption after all transmission repairs.
