PRE-RELEASE
INSTALLATION
| INSTALLATION |
Pass the harness assembly through the hole in the transmission case.
Connect the connectors of same color, and secure the connectors to valve body using clips. (Saab 9-2X 2.0T Aero)
Tightening torque (Transmission ground cable and ATF temperature sensor):
8 Nm (0.8 kgf-m, 5.8 ft-lb)
|
(A)
|
Lock-up
duty solenoid (Blue)
|
|
(B)
|
Low clutch
timing solenoid (Gray)
|
|
(C)
|
Line pressure
duty solenoid (Red)
|
|
(D)
|
Shift solenoid
2 (Yellow)
|
|
(E)
|
Shift solenoid
1 (Green)
|
|
(F)
|
2-4 brake
timing solenoid (Black)
|
|
(G)
|
2-4 brake
duty solenoid (Red)
|
|
(H)
|
ATF temperature
sensor
|
|
(I)
|
Transfer
duty solenoid (Brown)
|
|
(J)
|
Transmission
ground
|
Connect the harness connector and transmission ground. (Saab 9-2X 2.5i Linear)
Tightening torque:
8 Nm (0.8 kgf-m, 5.8 ft-lb)
|
(A)
|
Transmission
ground
|
|
(B)
|
Harness
connector
|
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Fluid packing:
THREE BOND 1217B (Part No. 32005004)
Apply liquid gasket fully to three holes other than screw holes on transmission case.
Fluid packing:
THREE BOND 1217B (Part No. 32005004)
Install the oil pan.
Tightening torque:
5 Nm (0.5 kgf-m, 3.6 ft-lb)
Connect the connector of rear vehicle speed sensor. (Saab 9-2X 2.5i Linear)
|
(A)
|
Rear vehicle
speed sensor
|
Install the rear vehicle speed sensor. (Saab 9-2X 2.0T Aero)
|
(A)
|
Rear vehicle
speed sensor
|
Install the front vehicle speed sensor and torque converter turbine speed sensor, and then fasten the harness.
Tightening torque:
7 Nm (0.7 kgf-m, 5.1 ft-lb)
|
(A)
|
Front vehicle
speed sensor
|
|
(B)
|
Torque
converter turbine speed sensor
|
Install the oil cooler pipes.
| Note | ||
|
Be sure to use a new copper washer. |
Tightening torque:
T1: 25 Nm (2.5 kgf-m, 18.1 ft-lb)
T2: 45 Nm (4.6 kgf-m, 33 ft-lb)
Install the transmission rear crossmember bolts.
Tightening torque:
70 Nm (7.1 kgf-m, 51 ft-lb)
Install the propeller shaft.
Install the shield cover. (If equipped)
Install the front, center, rear exhaust pipes and muffler. (Saab 9-2X 2.5i Linear)
Install the center, rear exhaust pipes and muffler. (Saab 9-2X 2.0T Aero)
Lower the vehicle.
Install the transmission connector to the stay.
Install the pitching stopper.
Install the air intake chamber. (Saab 9-2X 2.5i Linear)
Install the intercooler. (Saab 9-2X 2.0T Aero)
